Enum PowerIntent 

pub enum PowerIntent {
    PowerOff,
    EnterDfuUf2,
    EnterDfuSerial,
    Reboot,
}

Things the firmware can decide to do that take the device out of its normal operating state. All variants are terminal — the calling task must assume the device will be reset or powered off shortly after the intent is delivered.

Variants

PowerOff

Enter nRF52840 System OFF; wake on button press.

EnterDfuUf2

Reset into the Adafruit bootloader’s UF2 mass-storage DFU mode (GPREGRET = 0x57).

EnterDfuSerial

Reset into the bootloader’s serial / CDC DFU mode (GPREGRET = 0x4e). Required by the WebSerial-based MeshCore flasher and by adafruit-nrfutil --touch 1200.

Reboot

Plain warm reset back into the running firmware.

Trait Implementations

impl Clone for PowerIntent

fn clone(&self) -> PowerIntent

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for PowerIntent

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl PartialEq for PowerIntent

fn eq(&self, other: &PowerIntent) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for PowerIntent

impl Eq for PowerIntent

impl StructuralPartialEq for PowerIntent